Home > Electronics > DIY Parts & Tools > FT232RL FTDI USB2.0 to TTL Serial Adapter Module for Arduino 3.3V 5V
FT232RL FTDI USB2.0 to TTL Serial Adapter Module for Arduino 3.3V 5V

FT232RL FTDI USB2.0 to TTL Serial Adapter Module for Arduino 3.3V 5V

Item ID: 14008962

Sale Price:US$7.43

Total Price:
Quantity: Availability: In StockPrice Match
Buy More... Get Lower Price!
Quantity 1 2-4 5-9 10 or more
Unit Price US$7.43 US$6.92 US$6.69 US$6.47
Product Details

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.It is designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!).And it has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.
The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is CTS. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.

  • 100% Brand new and high quality
  • Use a  6-pin header on the bottom, which makes it smaller and more compact
  • Support 3.3V, 5V
  • Chipset FT232RL
  • USB power has over current protection, using 500MA self-restore fuse
  • RXD/TXD transceiver communication indicator
  • Pin definition: DTR,RTS,BLK,GRN,GND
  • Module size:Approx.3.1* 1.75cm/1.22 * 0.68inch
  • Interface: USB2.0

Package Includes:

  • 1 x FT232RL Module

Note:This board has a jumper on the back of the board that allows the board to be configured to either 3.3V or 5V (both power output and IO level). This board ship default to 5V, but you can cut the default trace and add a solder jumper if you need to switch to 3.3V.